Car batteries can lose their ability to crank an motor for any reasons. When they do, a quick jump-start will help recharge them. The key is to corollary a methodical process in order to ensure your personal protection while avoiding electrical problems.
The Non-Mechanic's Guide to Jump-Starting a Car Battery
You have probably heard that an automotive Battery can potentially explode. This is true, which is the fancy you should wear protective goggles while changing, cleaning, or jump-starting one. The danger is due to hydrogen gas contained within the unit. It can be ignited by an errant spark. That said, the danger is slight; exploding batteries are highly rare.
In this article, you'll contemplate the step-by-step procedure for properly jump-starting your car's Battery.
Preparatory Steps
A jump-start requires two vehicles, your own and the jumper - or booster - vehicle. Park the booster vehicle with its Battery as close as inherent to your own without the cars production contact. Then, turn the ignition off (as well as the radio and other devices) and set the parking brake on both automobiles.
Take a look at your jumper cables. One will be attached to a red clamp and the other will be attached to a black clamp. Ideally, the cables should be heavy-duty and the metal clamps should be completely clean of corrosion.
Next, take a look at the posts on both batteries. One will be confident and the other will be negative. The confident post should have a plus ("+") sign and the negative one should be marked with a minus ("-") sign.
Making The Connections
First, connect one of the red clamps to the confident post on your dead battery. Make sure the relationship is secure. Then, connect the other red clamp of the jumper cable to the confident post on the booster car's battery.
Connect one of your jumper cable's two black clamps to the negative post on the booster car. Then, connect the last remaining free clamp to the hull of your vehicle or to a metal ground somewhere on the Engine.
Sending The Charge
Start the jumper vehicle and let it idle for two or three minutes. Then, start your own automobile and let it idle. If your motor refuses to turn over, turn it off. There are likely other problems that need to be resolved. If you're persistent and keep trying to turn your motor over, you might cause damage to your Starter.
Assuming you're able to start your vehicle, disconnect the clamps of your jumper cables in the same order that you related them. Then, whether connect the battery to a charger or drive your car for approximately twenty minutes before turning the motor off.
Batteries occasionally lose their fee and need to be jump-started. It's a easy procedure, but it must be performed according to the guidelines above in order to ensure your protection and that of your vehicle.
The Non-Mechanic's Guide to Jump-Starting a Car Battery
Recommend : Alternator Repair kits Antifreeze Engine Coolant Cars Automotive Security Systems Best Automotive Diagnostic Tool
CERTAIN CONTENT THAT APPEARS
